Displaying Reconstruction Tile Results

To display point cloud, 3D model, or texture results for a tile:

1.     Select the required tile. See "Selecting Tiles" in this chapter. The Tile tab is displayed.

2.     On the Tile tab, in the Show group, toggle on any of the following options:

§  Point Cloud – Click the arrow to select the data to display:

·         Merged – Show point cloud created by supplementing LiDAR with points generated from photos where LiDAR information is insufficient.

·         From Photos – Show point cloud created only from points generated from photos.

·         From Lidars – Show point cloud created only from LiDAR points.

§  Model – Shows only the mesh model

§  Textured Model

§  Orthophoto – If RGB color bands were selected for the orthophoto, they are displayed. Otherwise, only the first band is displayed in grayscale mode. See "Selecting the Collections and Bands to Include in the Build Outputs" in this chapter for information.

Note:        Each of these options is enabled only if the build step for this data was completed.