Using Fusers

To use fusers on the master computer:

1.     In PhotoMesh Build Manager, select the required fusers.

2.     If you want PhotoMesh Build Manager to automatically use any new fusers that connect to the project’s working folder, select Automatically use new available fusers from the dropdown list.

3.     If there are no available fusers, a dialog is displayed asking if you want to start a local fuser. Click Yes to start a local fuser. Click No to start the build without adding a fuser. Processing will begin automatically when fusers are added.

4.     If you want to change the working folder that PhotoMesh Build Manager and PhotoMesh fusers use to communicate (to deposit and collect pending tasks, and share information about fuser availability, status and progress), click Browse. Then browse to the required location.

Note:        The working folder in the PhotoMesh Fuser dialog on the client computer should be set to the same location as the location set here. See "Fuser Management (on the client Computer)" in this chapter for information.