Creating Tie Points in Selected Photos

To create a tie point in selected photos:

1.     In the Project Tree, select the Photos group, and then in the Photos list, select the required photos.

2.     On the Photo tab, in the Tie Point group, click Create Tie Point. The Control Point Editor is displayed with the newly-created tie point selected in the control point table at the bottom of the Editor, and with a Custom selection in the Photos panel that includes all the photos selected in the Photos list.

Note:        You can also create tie points and filter the photos for sampling from the Editor itself: On the Home tab, in the Add group, click the arrow under Control Points and select Open Control Point Editor. Then on the Home tab of the Control Point Editor, in the Control Point group, click the arrow under Add New and select Add New Tie Point. See "Marking Control Points in Photos" in this chapter for information on filtering the photos for sampling.

3.     Set the tie point properties. See "Editing Control Points" in this chapter for information.

4.     Mark the tie point in the relevant photos, and then save the project. See "Marking Control Points in Photos" in this chapter for information. The Sampled Photos panel gradually becomes populated with photo thumbnails as you mark the tie point in photos.